Encoder hub on CF-Q-26-0940

Encoder hub, rev A

TurnedWith the quote desk

Back to the quote

DB-1130 rev A · 50 × 50 × 22 mm · 70 g in 6061-T6

Measured

This part’s measurements are below. Its 3D view isn’t in the demo.

Bore tighter than the rules priceØ12 +0.005/0 and 0.005 runout are tighter than the automatic range, so the quote desk prices them with the shop. Expect a quote within one business day. (Shaft bore)
A looser bore would price automaticallyIf Ø12 H7 (+0.018/0) works for the encoder, the quote could go out on the rules alone.
4 holesM4 × 0.7

Material, stock-aware

6061-T6Priced from the dated table1018On the dated table, the desk prices it4140On the dated table, the desk prices it

Stock: round bar Ø57 mm, cut to 25 mm

Finish

Tolerance

With the quote desk. Tight, ±0.025 mm or better is tighter than the rules price; a person prices this line and it shows with the quote desk until the reply.

With the quote desk. Bore Ø12 +0.005/0 and 0.005 runout are tighter than the rules price.

Threads, read from the drawing

3 × M4 × 0.7, 8 mm deep

Tapped as the drawing calls them. Inserts and fits come with the configurator’s next wave.

Inspection

A CMM report is priced by a person; the line shows with the quote desk until it replies.

Notes for the shop (optional)

Price breaks

Price breaks appear once the machining line is priced.

Economy7 Dec 2026the desk prices itStandard26 Nov 2026this price

Expedite is always priced by the quote desk.

This part is with the quote deskThe desk replies by emailpendingthe line waits